58 Connect USB Devices
VX5 User’s Guide E-EQ-VX5OGWW-F-ARC
Connect USB Devices
The VX5 provides an internal USB port and a provision for an external USB port via a dongle
cable attached to the connector marked “ETHERNET/USB” .
Internal USB Port
An internal USB port is provided behind the user access panel on the top of the VX5.
1. Loosen the three (3) Phillips head screws securing the access panel cover so the
cover can be removed. The screws are a captive part of the cover and cannot be
removed.
2. Plug the desired device, such as a USB mouse or floppy drive, into the USB port.
Refer to the documentation for your USB device for more details on installation.
USB devices may be installed, removed or swapped without turning off the VX5.
!
While the access panel is open, the VX5 IS NOT environmentally sealed.
The internal USB port should only be used when the VX5 is in a clean,
dry, dust free environment. Use the external USB port if a USB device
must be used in a harsh environment.
3. When finished with the USB device, unplug the device and reattach the user panel
access cover. The three screws must be fastened to 9±1 inch pounds each. The
screws require a Phillips size 1 driver head.
