Filter
Top Products
Appendix B: Upgrading the EMM-E6
B-2 EMM-E6 Installation Guide
B.2 ADDING EPIMS
This section contains procedures for adding or replacing an Ethernet
Port Interface Module (EPIM) to upgrade or change the capabilities of
your EMM-E6. After installing your new EPIM, refer to Chapter 3,
Installation, for network connection instructions.
To install an EPIM, perform the following steps:
1. Remove the coverplate or the existing EPIM (whichever applies).
2. Slide your new EPIM into place, making sure the connectors on the
rear of the module and inside the EMM-E6 attach properly. Refer to
Figure B-2.
3. Secure the EPIM to the EMM-E6 by tightening the mounting screw.
Figure B-2 Installing an EPIM
NOTE
The EMM-E6 EPIM slots are designed to provide redundancy.
Only one EPIM will be active at any time. The inactive EPIM
port will be held in standby, and will be immediately activated in
the event of a filure ofthe primary EPIM port.
!
CAUTION
Observe all antistatic precautions when handling sensitive
electronic equipment.
!
CAUTION
When removing an existing EPIM, make sure to pull the
module straight out to avoid damage to the connector.
EPIM
Mounting
Screw
LNK
1926n16
ICH1Book Page 2 Tuesday, August 6, 1996 3:06 PM