Filter
Top Products
Chapter 3: Installation
3-8 EMM-E6 Installation Guide
4. Firmly press the module connections into the backplane. Do not try to
force the module into place or use the knurled knobs to draw the
module into the backplane.
Figure 3-3 Installing the EMM-E6
5. Secure the module to the MMAC chassis by tightening the knurled
knobs. If you do not tighten the knurled knobs, vibration can cause the
module to lose contact with the backplane and disrupt your network.
6. Reinstall the MMAC chassis safety bars.
7. Power-up the MMAC (if it is not already ON).
8. Observe the status of the LANVIEW LEDs (Figure 3-4) on the
EMM-E6. When the CPU LED is amber, the module is in boot state.
During this approximately one minute period the EMM-E6 cycles
through a series of internal diagnostics.
Module Guide Channels
1926n07
ICH1Book Page 8 Tuesday, August 6, 1996 3:06 PM