Filter
Top Products
Programming
F232090
44
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Standard Supply Legend
Supplies are shown by number in the cycle charts. The
following table correlates the supply number with the
supply as it is represented in the cycle charts:
Standard Cycle Charts
For Models built after February 4, 2003
NOTE: The cycle shown is intended for setup of
supplies with a 5 supply system. If the machine is
equipped with 8 supplies, refer to Programming a
Supply Step – Models with 8 Supplies. As extra
supplies are normally controlled by bank 2,
program supplies 6, 7, 8, and 9.
NOTE: The alarm will sound on steps 01 and 02 (of
Test Cycle). These steps have been deliberately
programmed with times that are too short. Press
Start to continue when alarm sounds. The times
here are actual operating times if the steps are
allowed to progress to their end without pressing
Advance.
For Models built before February 4, 2003
Standard Supply Legend
Supply
Number
Supply Description
1 Detergent
2 Bleach
3 Sour
4 Softener
5 Specialty
Cycle 01
Formulas Common to All Markets
(Chemical Supply Setup)
Step Description Min:sec
1 Warm Fill to Low Level 5:00
2 Supply 1 2:00
3 Supply 2 2:00
4 Supply 3 2:00
5 Supply 4 2:00
6 Supply 5 2:00
7Wash 1 0:30
8Drain 1 1:00
Cycle 01 (Test)
Step Description Min:sec
1 Cold Fill to Low Level 0:30
2 Drain 1 0:10
3 Hot Fill to Low Level 5:00
4 Heat, 150°F (66°C) 1:00
5 Cold Fill to High Level 5:00
6 Supply 1 0:10
7 Supply 2 0:10
8 Supply 3 0:10
9 Supply 4 0:10
10 Supply 5 0:10
11 Supply 1 and 3 (Display: “SB”) 0:10
12 Wash 2 0:30
13 Wash 3 0:30
14 Wash 4 0:15
15 Wash 1, No Reverse 0:30
16 Drain 1 1:00
17 Warm Flush 0:30
18 Auxiliary 1 0:05
19 Auxiliary 2 0:05
20 Auxiliary 3 0:05
21 150°F (66°C) Fill to High Level 5:00
22 Cold Fill to Overflow 1:00
23 Soak 2:00
24 Drain 1 1:00
25 Medium Spin 0:15
26 Warm Spray Rinse 0:30
27 High Spin (SDLY 0:15) 1:00