Filter
Top Products
Programming
F232090
42
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
9. Press the ENTER key. The simulator display
will flash “RECV” and “CYC” alternately. The
computer display will flash “SEND” and “CYC”
alternately.
When the two displays stop flashing, the transfer
is complete.
Transferring All Cycles from Simulator to
Computer
All keypad commands will be entered with the
simulator keypad.
Use the following procedure to transfer all cycles
contained in the memory of the simulator to the
computer. (Transferring 39 cycles takes about 6
seconds.)
1. Connect the fiber optic cables between the
simulator and the computer. Verify that the
colored plugs on the ends of the optic cables
match the colors of the ports on the simulator and
on the washer-extractor’s control module (gray to
gray, blue to blue).
2. Place both the simulator and the computer in the
PROGRAM mode. The display on both will read
“CYC00.”
3. Press the 0 key. The display will read “WRITE?”
4. Press the ENTER key. The display will read
“ALL.”
5. Press the ENTER key again. The simulator
display will flash “SEND” and “ALL”
alternately. The computer display will flash
“RECV” and “ALL” alternately.
When the two displays stop flashing, the transfer
is complete.
Transferring One Cycle from Simulator to
Computer
All keypad commands will be entered with the
simulator keypad.
Use the following procedure to transfer one cycle
contained in the memory of the simulator to the
computer. (Transferring 1 cycle takes less than 1
second.)
1. Connect the fiber optic cables between the
simulator and the computer. Verify that the
colored plugs on the ends of the optic cables
match the colors of the ports on the simulator and
on the washer-extractor’s control module (gray to
gray, blue to blue).
2. Place both the simulator and the computer in the
PROGRAM mode. The display on both will read
“CYC00.”
3. Press the 0 key. The display will read “WRITE?”
4. Press the ENTER key. The display will read
“ALL.”
5. Press the 0 key. The display will read “CYC00.”
6. Press the ENTER key. The display will read
“RCYC00.”
7. Now press the 2-digit code for the desired cycle
number from the simulator.
8. Press the ENTER key. The display will read
“WCYCcc.”
9. Now press the 2-digit code for the desired cycle
number under which the cycle should be saved in
the computer.
10. Press the ENTER key. The simulator display
will flash “SEND” and “CYC” alternately. The
computer display will flash “RECV” and “CYC”
alternately.
When the two displays stop flashing, the transfer
is complete.