Filter
Top Products
Operation
21
F232090
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Stop Routine
A lengthy stop procedure ensures that the basket has
adequate time to stop (from the machine’s highest
speed) before the computer allows the door to be
opened. This is an important safety feature.
During the normal stop routine at the end of the cycle,
the computer will display “STOP” and turn off all
outputs.
A 30-second shakeout (Wash 1) is included as part of
the stop procedure. If additional shakeout is desired,
see Programming a Spin Step in the Programming
section of this manual.
The remainder of the stop routine is fixed at the
following:
● low speed forward for 15 seconds
● pause for 5 seconds.
The computer will display “DONE,” and the door can
be unlocked. The computer will continue to display
“DONE” until the operator opens the door. Once the
door is opened, the display will change to “NEXT.”
Balance Switch Detection
The washer-extractor is equipped with a balance
switch detection system whereby the switch installed
between the faces of the A-frame signals the computer
to slow the washer-extractor when an out-of-balance
load occurs during extract.
If the balance switch is tripped, the out-of-balance
LED indicator located in the upper left corner of the
first digit of the display will light and will remain
lighted until the end of the extract step. This indicator
tells the operator that an out-of-balance condition
existed during an extract step. The washer-extractor
will attempt to balance three times during an extract
step.
If on the third attempt the out-of-balance condition
continues, the washer-extractor will advance to the
next step. (If the next step is another spin step, it will
be skipped also.)
NOTE: This feature applies to the UW60 only.
NOTE: The computer cannot advance through a
drain step.
Temperature Display
The temperature display can be prompted to display in
Fahrenheit or Centigrade. See Prompting the WE-6 in
the Programming section of this manual.
To display temperature, press the Display Temp key.
The display will read “F” or “C” and the temperature
as long as the key is pressed. The computer will update
the display automatically.
NEVER insert hands or objects into
basket until it has completely stopped.
Doing so could result in serious injury.
SW012
WARNING