Filter
Top Products
Operation
19
F232090
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Opening Door
Use left hand to press and hold the door unlock button
located on the lower right front of the control panel.
See Figure 6.
Use right hand to turn door handle clockwise and
swing the door left to open. See Figure 7.
Loading
Load the machine to full capacity whenever possible,
but do not exceed the rated dry-weight capacity of the
machine if the fabric to be washed is quite dense,
closely woven, and heavily soiled. Overloading can
result in an inferior wash. The operator may need to
experiment to determine load size based on fabric
content, soil content, and level of cleanliness required.
Partial loads are a waste of energy, water, and
chemicals, and cause greater machine wear than full
loads. Partial loads also increase the possibility of a
severe out-of-balance condition.
When loading is complete, ensure that all fabric is
inside the basket. Then close and lock the door.
NOTE: When washing items which may
disintegrate or fragment, such as mop heads or
sponges, use laundry nets to prevent drain
blockage.
Supply Dispenser
Dry supplies are placed in the supply dispenser
compartment cups prior to the start of each cycle.
Liquid supplies can be injected directly into the supply
dispenser by an external chemical supply system.
NOTE: Supply dispenser compartment cups must
not be removed when an external chemical
injection supply system is attached to the washer-
extractor.
Cycle Selection
NOTE: Press keys at their centers just hard enough
to activate them.
Find the cycle number of the desired wash cycle from
the preprogrammed cycle charts in the Programming
section of this manual. Cycle numbers must be two-
digit numbers from 01 to 39.
Press the numbers desired on the keyboard and note
that these numbers are displayed after “NEXT.”
When keys are pressed on the keyboard, a beep will be
heard. If an error is made, press the numbers again. As
numbers are entered, they move from right to left on
the display.
NOTE: If the washer-extractor is equipped with
both steam and electric heat, the selector switch on
the right side of the control module must be in the
correct position for the desired heat source, down
for steam heat, up for electric heat.
MD003J
Figure 6
MD004J
Figure 7