Filter
Top Products
Programming
F232090
38
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Programming a Soak Step
1. The computer must be in the PROGRAM mode,
and the cycle programming sequence must be
ready for the next step. (The previous step should
have been a fill and/or supply step.)
2. Press the Soak key. The display will read
“SKnncc.”
With machines equipped with auxiliary heat
(optional steam or electric), it is possible to
program a soak-with-temperature step. During
such a step, the machine will soak for the time
programmed at the temperature programmed and
will maintain that temperature throughout the
step.
To program a soak with temperature step use the
following procedure:
a. Press the Heat key after pressing the Soak
key. The display will read either “080Fcc” or
“025Ccc,” depending on whether Fahrenheit
or Centigrade is prompted.
b. Enter the temperature desired for the machine
to maintain during the soak step. Three digits
must be entered for the temperature. If the
desired temperature is less than 100 degrees,
the first digit should be 0. The valid
temperature range is 80–200 degrees
Fahrenheit and 25–93 degrees Centigrade.
The computer will not accept temperatures
outside of this range. If 100 degrees
Fahrenheit is selected, the display will read
“100Fcc.”
3. Press the Enter key. The display will read “H---
M.” Now assign the soak step the desired time in
hours and minutes. During the soak step, no
agitation will occur. The WE-6 microcomputer
will maintain the water level during the soak
cycle at whatever previous level was
programmed.
4. Press the Enter key and go to the next step in the
cycle.
Programming a Drain Step
1. The computer must be in the PROGRAM mode,
and the cycle programming sequence must be
ready for the next step.
2. Press the Drain key. The display will read “D-
nncc.”
3. Press key 1 for a regular drain to sewer or a floor
drain. The display will read “D1nncc.”
4. Press the Enter key. The display will read “M---
S.” Now assign the time which will allow the
machine to drain to empty.
This is an alarm time. The machine should drain
in 30 seconds under normal conditions. The
recommended drain time is one minute. Drain
times of more than one minute are not
recommended.
5. Press the Enter key and go to the next step in the
cycle.
NOTE: When programming a drain step, it is
important to select Drain 1. Drain 2 is not available
on the UW60 2-speed or 3-speed washer-extractors.
Programming a Flush Step
When the Flush key is pressed, the drain will remain
open and the basket will rotate in slow speed forward
only. Water is added only through the door spray
nozzle.
1. The computer must be in the PROGRAM mode,
and the cycle programming sequence must be
ready for the next step.
2. Press a water temperature key, either Cold, Hot,
or Warm. If the Cold key is pressed, for
example, the display will read
“C-nncc,” etc.
3. Press the Flush key. The display will read
“CFnncc,” “HFnncc,” or “WFnncc,” depending
upon the temperature selected.
4. Press the Enter key. The display will read “M---
S.” Now assign the desired flush time in minutes
and seconds.
5. Press the Enter key and go to the next step in the
cycle.