Filter
Top Products
Programming
F232090
28
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
24. Press the Enter key. The display flashes “SDLY”
for one second.
The display will then read “0M-00S,” allowing
the programmer to enter the time for a slow down
delay (coast).
At some point in the future–to have the basket
coast before it stops, enter the desired coast time
(up to 99 seconds). However, do not enter a time
now. That would cause a coast before a higher
spin speed (which will be the next step).
For no coast, press the Enter key.
25. The next step is to program a high-speed spin.
a. Press the High Speed key once. The display
will read “HS1139.”
b. Press the Enter key. The display will read
“M---S.”
c. Enter a length of time for the high-speed spin
(six minutes). Press key 6. The display will
read “6M-00S.”
NOTE: High-speed spin is preceded automatically
by medium-speed spin for 30 seconds for
nonvariable-speed UW rigid-mount models.
26. Press the Enter key. The display will flash
“SDLY” for one second. (“SDLY” also displays
during the entire actual coastdown.) The display
will then read “0M-00S,” inviting the
programmer to enter a time for the slow-down
delay (coast). If the application requires that the
basket coast before it stops, enter the desired
coast time (30 seconds here) and press the Enter
key. If no coast is desired, press the Enter key
only. The display will read “1239.”
NOTE: A slow-down delay of 30 seconds minimum
should be programmed after each high-speed spin.
All the preprogrammed and optional cycles in this
manual reflect this practice.
27. The previous step ends the tutorial. Cycle 39,
consisting of 11 steps, has been completely
programmed.
To end the cycle, turn the program mode switch
located on the left side of the control module to
the RUN position and remove the key. The
display will then
read “NEXT.”
The programmer can now select Cycle 39 and
press the Enter key to run the cycle, if desired; or
a cycle of the programmer’s own design can be
programmed.
Tutorial Cycle
Step Description Min:sec
1 Hot Fill to Low Level 4:00
2 Supply 1 0:30
3 Wash 1 6:00
4Drain 1 1:00
5 Warm Spray Rinse 2:30
6 Warm/Warm Fill to High Level 5:00
7 Supply 3 0:30
8 Wash 1 3:00
9Drain 1 1:00
10 Medium Speed Spin 1:00
11 High Speed Spin
SDLY
Stop Routine
6:00
0:30