Filter
Top Products
Programming
31
F232090
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Cycle Programming
Displaying a Cycle in Memory
1. Insert key into the program mode switch (located
on the left side of the control module) and turn
key to the PROGRAM position. The display will
read “CYC00.”
2. Press the Edit Cycle key on the keypad. The
display will read “DCYC00.”
3. Press the two-digit code to display the desired
cycle number: For example, press key 2 and then
key 5 to select cycle 25. The display will read
“DCYC25.”
4. Press the Enter key. The computer will search
for cycle information for this cycle number.
If no cycle information exists, the computer will
flash “NCYC25” followed by “ADD?” To add
this cycle, press the Enter key and proceed to the
add cycle programming mode. If adding this
cycle is not desired, press the Clear key, and the
computer will then return to the normal
programming mode.
5. If cycle information does exist for cycle 25, the
computer will display “0425,” for example, to
indicate that cycle 25 has been run four times. To
clear the count (reset it to zero), press key 0. The
display will then show “0025.”
If clearing the count is not necessary or if it has
just been cleared, press the Enter key. The
computer will now display “HL0125,” indicating
the first step of cycle 25.
6. Press the Advance key to move to the next step
of the cycle. To access further information
pertaining to each step (for example, temperature
and/or time), press the Enter key. If the display
shows a temperature, press the Enter key again
to display the time. Press the Enter key once
more to advance to the next step.
7. At the end of the cycle, the computer will display
“END-25” for two seconds and return to the
normal programming mode.
8. Return the program mode switch to the RUN
position and remove the key.
NOTE: Never press the Clear key while displaying
a cycle in memory except to edit or delete a step.
Displaying Individual Cycle Usage
1. Insert key into the program mode switch (located
on the left side of the control module) and turn
key to the PROGRAM position. The display will
read “CYC00.”
2. Press the Edit Cycle key on the keypad. The
display will read “DCYC00.”
3. Press the two-digit code to display the desired
cycle number: For example, press key 2 and then
key 5 to select cycle 25.
4. Press the Enter key. The display will show
“xx25.” (The “xx” here stands for the number of
times cycle 25 has been run and will be
represented by numbers in the actual display.)
The computer will remain in this step until one of
the following options has been chosen:
● Press the Enter key to continue displaying the
cycle, OR
● Press the Clear key to return to the normal
program mode, OR
● Press key 0 to reset the counter for this cycle
to zero, OR
● Take the computer out of the program mode.