Filter
Top Products
21
5. The tub assembly is secured to the tub
support at three locations. There are two
screws, a suspension spring and a locat-
ing tab at each of these locations.
(Fig. 3-17)
SERVICING THE DRIVE MOTOR AND PUMP
The drive motor and pump can be accessed by removing the cabinet. The pump is a sealed unit and
cannot be serviced. It should be replaced if it does not operate properly. The pump engages the drive
motor directly and is held in place by two retainer clips.
(Fig. 3-18)
4. Complete the removal of the basket by
loosening the spanner nut on the spin tube
and expand the drive block with a wide
bladed screw driver.
(Fig. 3-16)
The bas-
ket can now be lifted straight up and out
of the tub.
3. The Surgilator Agitator is removed by first
pulling off the agitator cap and inner cap.
Then unscrew the 7/16” bolt found un-
der the cap and pull straight up on the two-
piece agitator assembly. The clutch and
clutch dogs that provide the Surgilator ac-
tion are found in the upper portion of the
agitator assembly.
(Fig. 3-15)
Fig. 3-15
Clutch
Clutch Dogs
Fig. 3-16
Spanner Nut
SUSPENSION
PLATE
BASE
SPRING
BRACKET
SUSPENSION
SPRING
Fig. 3-17
Fig. 3-18
Agitator Cap
Inner Cap