Filter
Top Products
115
Dryer Drive Motor Access
1. Remove the Toe Panel.
2. Remove the Dryer Lint Screen.
3. Remove the Dryer Lint Duct Assembly.
4. Remove the Blower Assembly, Transition
Duct and Blower Plate by removing the re-
taining screws.
(Fig. 5-29)
5. Using a ratchet and extension to hold the drive
motor shaft stationary, remove the Blower
Wheel.
Fig. 5-29
5. Remove the top two (2) retaining screws.
6. Remove the bottom two (2) screws.
7. Remove the Lint Screen.
8. Remove the three (3) Dryer Lint Duct assembly
retaining screws and remove the assembly.
(Fig. 5-28)
9. Remove the four (4) heater element shield
screws.
(Fig. 5-28)
10. The Dryer Front Panel can now be removed.
Fig. 5-28
Retaining
Screws
Screws
Screw
Screw
Heater
Element
Shield
Lint Duct
Assembly
NOTE: The Blower is reverse threaded and is removed by turning it clockwise.