Filter
Top Products
6
JOG (Forward/Reverse Push-Buttons)
These two (2) push-buttons, located towards the left side of the Right Front Control Door, are for either loading
or unloading the tumbler (basket). JOG functions are only enabled when the doors are open.
NOTE: There is a PLC controlled DWELL TIME between forward jog or reverse jog
selection to prevent plug starting the tumbler (basket) drive motor.
LOAD/DRY/UNLOAD (Three [3] Position Selector Switch)
TILT (Off - On) (Two [2] Position Selector Switch)
The LOAD/DRY/UNLOAD and TILT (Off - On) selector switches work in conjunction with each other. If
the TILT selector is in the OFF position, an UNLOAD or LOAD selection will open the front horizontal
doors, allowing an operator to load or unload the tumbler (basket) in the level position.
NOTE: The ML-410 JOG feature will respond in the level position. The Lint Drawer must be
closed for the JOG feature to operate.
If the TILT selector is in the ON position, an UNLOAD selection will open the front vertical doors and tilt
the tumbler (basket) section towards the front (Rear Up). Likewise, a LOAD selection will open the front
horizontal doors and tilt the tumbler (basket) section towards the rear (Front Up).
The DRY selection will bring the tumbler (basket) section to a level position and close the front horizontal
doors. Once ALL safe conditions are met (i.e., front doors closed, lint drawer closed, machine level), an operator
will be able to select a drying cycle on the Phase 7 Microprocessor Controllers (computer) keyboard (touchpad)
located on the Right Front Control Door. Refer to the Phase 7 Operators Manual for details.
CONTROL POWER (On)
This green lighted operator, located on the Right Front Control Door, is for enabling the dryers control voltage.
This push-button must be ON for drying or load/unload function to occur.
CONTROL POWER (Off)
This red non-lighted operator, located on the Right Front Control Door, is for disabling the dryers output
control voltage. This push-button is mainly for use as a troubleshooting function.
END OF CYCLE/AIR JET
This amber colored indicator located on the top of the ML-410 has two (2) functions:
1. To indicate that a drying cycle has been completed and that the dried material is ready for attention. Once
the dryer is attended (i.e., lint drawer is opened, or the UNLOAD - DRY - LOAD selector is turned to
either the UNLOAD or LOAD position and the vertical doors open) the indicator will go off.
2. The Air Jet will be activated at the end of the drying cycle when the End of Cycle light has been energized.
The Air Jet will remain active for approximately thirty (30) seconds to remove lint which may have
accumulated on the Blower Wheel (squirrel cage).