Filter
Top Products
F232072 31
Programming
y. All outputs are turned off for roughly 20
seconds. The display shows “SdLY” (spin
coast delay).
z. The computer performs the normal stop
routine.
The door interlock is energized (allowing the
door to be opened), provided that the water
level switch indicates that water has fallen
below low level and that the AC drive
indicates that the motor has stopped.
Chemical Injection Supply System
The external supply connections are located on the
rear of the machine. The supply dispenser
compartments are designated 1, 2, and 3, in that
order, viewed from the front of the machine, left to
right.
The external supply hoses empty into the supply
dispenser compartments as follows: external supply
1 empties into compartment 1, external supply 2
empties into compartment 2, and external supplies 3
and 4 empty into compartment 3. See Figure 4.
Figure 4
Compartment 1 flushes with each fill. Compartment
2 flushes when the program calls for supply 2
during a fill. Compartment 3 flushes when the
program calls for supply 3 during a fill.
Note: Compartment 3 does not flush when supply 4
is called for in a program.
Supply Dispenser
Compartments
Chemical Supply
Injection Points
1
2
3
1
2
3
4
B009RE3B