Filter
Top Products
Operation
14 F232072
Theory of Operation (Continued)
Note: Never turn the power off while the computer
mode switch is in the PROGRAM position. Such
action will disorder portions of the programmed
data, necessitating reprogramming of some or all of
the existing cycles. Always return the mode switch
to RUN position before turning the power off.
Keypad
Operation of the V-computer control is performed
with a 4-key touch keypad and LED display located
on the front of the machine. See Figure 3 for
domestic and international versions of the keypad.
The following table describes the function of the
individual keys when the machine is in RUN mode.
Figure 3
Keypad
Key Description
Up
Used in cycle selection; pressing this key moves
among cycles from smaller to greater.
Down
Used in cycle selection; pressing this key moves
among cycles from greater to smaller.
Start Used to start a cycle.
Stop Used to stop a cycle.
Up Down Start Stop
R076RE3A
Medium Water
Level
High Water
Level
Out-of-Balance
Condition
Domestic International
Low
Water
Level