Filter
Top Products
F232072 23
Section 3
Programming
The V-computer board is inside the control module.
Near the center of the board is a small toggle
switch: this is the RUN/PROGRAM mode switch.
The switch is normally in the down (RUN mode)
position. To enter PROGRAM mode, flip the switch
to the up position. The display will now show the
current temperature in the sump.
Since the keypad operates in a slightly different
fashion when in PROGRAM mode, pay careful
attention to the programming instructions provided
in this manual.
Key Functions in Programming Mode
Up–The Up key is used to increase cycle numbers
(1 through 30) and other numerical values such as
times or temperatures (when creating wash
formulas).
Down–The Down key is used to decrease cycle
numbers (1 through 30) and other numerical values
such as times or temperatures (when creating wash
formulas).
Start–The Start key acts as an enter key in program
mode. Use this key to enter data and move to the
next function in the cycle.
Stop–The Stop key saves all data and terminates
the programming procedure. If it is the first key
pressed in PROGRAM mode, the computer enters
SETUP mode. The Stop key can be pressed again to
exit SETUP mode and return to PROGRAM mode.
Setup Mode
SETUP options are programmable options that are
in effect for all wash formulas. These options
include:
Degrees displayed in Fahrenheit or Celsius
Auxiliary heat enabled or disabled
Supply 5 or Auxiliary fill
Temperature-controlled fill enabled or disabled
Automatic cool-down enabled or disabled
Note: These options can be read or changed only in
SETUP mode.
Dangerous voltages are present in the electrical
control box(es) and at the motor terminals. Only
qualified personnel familiar with electrical test
procedures, test equipment, and safety
precautions should attempt adjustments and
troubleshooting. Disconnect power from the
machine before removing the control box cover,
and before attempting any service procedures.
WARNING
SW005