Filter
Top Products
Programming
28 F232072
Cycle Programming (Continued)
7. Use the Up or Down key to select the desired
supply option. See the table below.
8. Press the Start key.
9. If the temperature-controlled fill or the
auxiliary heat SETUP option is enabled, use the
Up or Down key to select the desired segment
temperature. To disable auxiliary heat and
temperature-controlled fill for this segment, set
this value to zero. Press the Start key.
10. Use the Up or Down key to select the desired
drain option. If “drAI” is selected, the machine
will drain after the segment time has elapsed. If
“nodr” is selected, the machine will not drain
and the spin step will be skipped entirely. Press
the Start key.
Note: The drain step in the final program segment
cannot be skipped.
11. Final “FIL9” spin only. Use the Up or Down
key to select the desired spin speed. See the
table below.
12. Press the Start key.
13. Use the Up or Down key to select the desired
spin time. Set this value to zero to skip the spin
step. Press the Start key. The display will now
show the identifier for next program segment or
cycle option.
Note: Every intermediate spin is followed by a
25-second coast-down period, which occurs during
the fill step for the following segment.
14. Press the Stop key at any time to complete the
cycle programming procedure.
Test Cycle
1.Verify that the RUN/PROGRAM mode toggle
switch is in the RUN position.
2. Press the Up or Down key until the display
alternately flashes “tESt” and “CYC,”
indicating that the test cycle is selected.
3. Press the Start key to begin the test cycle.
Supply Options
Display Supply
SUP0 No Supply
SUP1 Supply 1
SUP2 Supply 2
SUP3 Supply 3
SUP4 Supply 4
SUP5 Supply 5*
SUP6 Supply 1 and 5*
SUP7 Supply 3 and 4
*This is available only if the “SUP5”/“AFIL” SETUP
option is set to “SUP5.”
Spin Options
Display Spin Speed
SPn1 Low Spin
SPn2 Medium Spin
SPn3 High Spin