Filter
Top Products
Operation
18 F232072
Supply Dispenser
The 18-pound and 25-pound capacity freestanding
models are equipped with a three-compartment
polypropylene supply dispenser. The supply
dispenser is mounted at the left top of the machine
as seen from the front. Both liquid and powder
supplies may be added by raising the flexible cover
of the dispenser.
Cycle Selection
Note: Press keys at their centers just hard enough to
activate them.
Press the Up or Down key until the desired cycle
number is displayed. Press the Start key to start the
cycle. For a more detailed description of the
preprogrammed cycles, see the cycle charts at the
end of the Programming section.
If the computer detects that the door is not properly
closed when the Start key is pressed, the display
will read “door” until the door is closed and locked.
Press Start again to begin the desired cycle.
Cycle Execution
A cycle can be stopped at any time by pressing the
Stop key. The machine will go to the stop routine.
When the routine is complete, the door may be
unlocked.
To display the temperature of the water while a
cycle is running, press the Up key. To display the
number of the cycle in progress, press the Start key.
Note: The computer does not count down the
remaining cycle time during fills, drains,
cool-down, or prior to first achieving the
programmed heat temperature when heating. The
computer resumes counting down cycle time once
the programmed fill level is reached, when the
machine has drained, and after a programmed heat
temperature is reached.
Each of the 30 cycles consists of 11 segments:
Prewash, Wash, and Fills 1 – 9. A description of the
various steps in a cycle segment follows:
Fill
After the Start key is pressed, the door locks, the
drain closes, and the machine begins filling to the
programmed level. Each programmed segment
begins with a fill. The display counts down the
remaining cycle time in minutes and seconds while
the cycle is running.
If a supply is programmed in a step, the supply
dispenser will flush during the fill of that segment.
If the machine is connected to an external chemical
supply system, the programmed supply will begin
10 seconds into the fill. The supply will remain on
until the programmed water level is reached, or
until 60 seconds have elapsed, whichever happens
first.
If agitation options 1 or 2 are selected for the cycle
program, the cylinder will rotate slowly during the
fill step. If agitation options 3 or 4 are selected for
the cycle program, the cylinder will not rotate
during the fill step. See the Agitation Options table
for more information.