Filter
Top Products
Operation
20 F232072
Spin
After the drain sequence ends, the speed of the
cylinder increases to the extract speed if the
programmed spin time is not zero. The displayed
time resumes counting down at one-second
intervals.
After the programmed spin time has elapsed, the
computer moves on to the fill step in the next
segment of the cycle. If the spin is at the end of the
cycle, the computer begins the stop routine.
Test Cycle
A test cycle is provided as a means of verifying
proper machine operation. Before the test cycle is
run, it must be enabled. Refer to the Programming
section of this manual for instructions on enabling
and running the test cycle.
Stop Routine
When the computer concludes the wash cycle or
when the Stop key is pressed while a cycle is in
progress, the computer goes into the stop routine.
The stop routine consists of a brief countdown and a
brief reversing sequence, after which the computer
will display “dONE.”
Once “dONE” is displayed, open the door by
pressing and holding the door unlock button as
described earlier. Once the door is opened, the
computer display will show the most recent cycle
number.
The machine is now ready to begin another wash
cycle.
Note: If the stop routine seems excessively long,
check for “FULL” or “rotA” messages. If this
occurs, contact a qualified service technician.
Balance Detection
Each model comes equipped with an inverter drive
balance detection system. Load balance is detected
by the inverter drive during any drain step that
immediately precedes a spin step. The V-series
computer will make up to seven attempts to balance
the load during a drain step.
The computer begins monitoring the balance signal
from the inverter drive eight seconds after the water
level drops below low level. If the balance signal
indicates that the wash load is evenly distributed,
the computer will start the spin step.
If the balance signal indicates that the wash load is
unbalanced, the computer will slow the cylinder
down to wash speed for seven seconds in an attempt
to redistribute the load. The computer will make as
many as seven attempts, if needed.
If on the seventh attempt the load is not balanced,
the machines will light the out-of-balance LED
indicator located in the upper left corner of the
display (to the left of the first digit) until the drain
step is complete. The machine will then ignore the
programmed spin and use a safe spin speed (not to
exceed 85 G’s) for the extract step, provided
programmed spin time is not zero.
If the load cannot be properly distributed, the
computer skips the spin and moves on to the next
segment. If the segment is at the end of a cycle
program, the computer goes into the stop routine.
The out-of-balance LED indicator will remain lit
until the door is opened.
NEVER insert hands or objects into basket until it
has completely stopped. Doing so could result in
serious injury.
WARNING
SW012