Filter
Top Products
25
7. After the curing period, install the main door on the dryer by reversing Step #4 through Step #1.
NOTE: Once the silicone is cured you may want to trim any excess silicone on the inside of the main
door assembly.
To Replace Front Panel
1. Discontinue electrical power to the dryer.
2. Remove bottom lint door assembly.
3. Remove the front panel by removing the screws.
IMPORTANT: When pulling the front panel off, the door switch harness in the upper right hand
corner must be unplugged.
NOTE: The main door assembly can be removed to make the panel removal easier. Refer to
“Replace Main Door Assembly” directions.
4. Disconnect other door switch wiring switch from the old panel and reinstall on the new front panel.
5. Reinstall the new front panel by reversing Step #1 through Step #3.
6. Reestablish electrical power to dryer.
To Replace Main Door Hinge Block
1. Discontinue electrical power to the dryer.
2. Follow procedure for removal of main door assembly for top hinge removal.
3. Remove the two screws from the bottom hinge block.
4. Reassemble by reversing removal procedure.