Filter
Top Products
17
A. COMPUTER CONTROLS
To Replace Computer Board
1. Disconnect electrical power to dryer.
2. Unplug keyboard ribbon from rear of computer.
3. Unplug all wiring harnesses connected to the
computer board.
4. Remove the two (2) screws securing the computer
to the computer panel. Remove the computer by
pulling the other two corners off the clinch studs.
5. Install new computer by reversing this procedure.
To Replace Keyboard Label Assembly
1. Discontinue electrical power to the dryer.
2. Unplug keyboard ribbon from rear of computer.
3. Slowly peel off and remove keyboard label assembly from control panel.
4. Peel paper backing off new keyboard label assembly.
5. Holding the new keyboard label assembly close to the panel, insert the keyboard ribbon through the rectangular
slot in the control panel. Align label assembly into position by matching the red viewing window on the label
to the rectangular cutout in the panel and gently press into place.
6. Connect keyboard ribbon to the computer.
7. Reestablish electrical power to dryer.
To Replace Microprocessor Temperature Sensor Probe
1. Discontinue electrical power to the dryer.
2. Open lint door.
3. Remove microprocessor sensor bracket assembly from
dryer.
a. Disconnect sensor bracket harness connector.
b. Loosen the two (2) Phillips head screws which
secure bracket assembly to dryer and remove
bracket from dryer.
NOTE: DO NOT remove screws.