Filter
Top Products
24
To Replace Main Door Assembly
1. Open main door.
2. Holding the door upward remove the two (2) screws from the top hinge block.
3. Lift the door up to remove.
4. Reverse this procedure for reinstalling new main door assembly.
To Install New Main Door Glass
1. Remove main door assembly from dryer (follow main door removal procedure).
2. Lay main door on flat surface with back of door face down.
3. Remove glass and clean all old sealant off main door. This area must be completely clean for correct bonding.
4. Apply a narrow bead of silicone (ADC P/N 170730) all around main door area where glass will rest.
5. Install glass onto door and adhesive. Slightly/gently press glass into place.
6. The door assembly should now be put in an area where it will not be disturbed for a few hours. This will give
the silicone a chance to harden.
IMPORTANT: DO NOT press hard or silicone thickness between the glass and door will be
reduced, resulting in poor bonding.