Filter
Top Products
23
To Replace Sail Switch
1. Discontinue electrical power to the dryer.
2. Remove the two (2) screws which hold the sail switch box cover to sail switch box.
3. Disconnect the two (2) wires from the switch.
4. Disassemble sail switch from mounting bracket by removing the two (2) screws securing switch in place.
5. Reverse this procedure for installing new sail switch. Adjust sail switch described in the next section.
To Adjust Sail Switch
With the dryer operating at a high temperature setting, pull the sail switch away from the burner. The sail switch
should open and extinguish the burner. Let the sail switch damper return to the burner wall. The sail switch
should close to restart the burner ignition cycle. If the sail switch circuit does not operate as described, bend the
actuator arm of the sail switch accordingly until proper operation is achieved. To check proper “open” position of
sail switch, open main door, manually depress main door switch and start dryer. With the main door open and the
dryer operating, the sail switch should be open, and the burner should not come on.
CAUTION: DO NOT abort this switch by taping or screwing sail switch damper to burner.
PERSONAL INJURY or FIRE COULD RESULT.
E. FRONT PANEL and MAIN DOOR ASSEMBLIES
To Replace Main Door Switch
1. Discontinue electrical power to the dryer.
2. Open main door.
3. Remove the two (2) Phillips head screws holding the main door switch
bracket assembly in place.
4. Disconnect wiring from switch assembly.
5. Reverse this procedure for installing new door switch assembly.
6. Reestablish electrical power to dryer.
.
IMPORTANT: UNDER NO CIRCUMSTANCES should the door switch be disabled.