Error & Status Messages on the Control Panel
57
5
P= XX I= XXXXXXXX
Power Off On
/ If Error Reoccur
Call Service
A controller error. The SC
number indicates the problem.
Turn the power off, and then on. If the
message appears again, call your sales
or service representative.
Processing... Print data is being processed. Wait a while.
RC Gate
connection error
Cannot communicate with RC
Gate.
Check the device or the RC Gate net-
work connection.
Ready The default ready message. The
printer is ready to use.
No action required.
Remove Misfeed
Duplex Unit
/ Open Duplex
Unit Cover
There is misfeed in the Duplex
Unit.
Remove the misfed paper.
See p.76 “When “Remove Misfeed
Duplex Unit” Appears”.
Remove Misfeed
Internal Path
/ Open
Front Cover
There is a misfeed in the printer. Remove the misfed paper.
See p.71 “When “Remove Misfeed In-
ternal Path” Appears”.
Remove Misfeed
Paper Exit Cover
/ Open Paper
Exit Cover
There is a misfeed in the paper
exit cover.
Remove the misfed paper.
See p.73 “When “Remove Misfeed Pa-
per Exit Cover” Appears”.
Remove Misfeed
Paper Tray
/ Pull out Tray
Paper is jammed in the speci-
fied input paper tray.
Remove the misfed paper.
See p.70 “When “Remove Misfeed Pa-
per Tray” Appears”.
Remove Paper
Standard Tray
The standard tray is full, and
the print job is suspended.
Remove paper from the standard tray,
and the print job will be resumed au-
tomatically.
Replace
Maintenance Kit
It is time to replace the mainte-
nance kit (friction pad, paper
feed roller, transfer roller and
fusing Unit).
Replace the new maintenance kit.
See p.32 “Replacing the Maintenance
Kit”.
Replace
Toner Cartridge
The toner cartridge is not set
correctly or toner is almost run
out.
Set the toner cartridge correctly.
See p.29 “Replacing the Toner Car-
tridge”.
The toner dust is full. Prepare a new toner cartridge. If the
image density gets too light, replace
the toner cartridge with a new one.
See p.29 “Replacing the Toner Car-
tridge”.
Reset Duplex
Unit correctly
A communication error sent
from the system unit to the du-
plex unit.
Set the duplex unit correctly. If the
problem persists, call your service
provider.
Messages/Second
messages
Description Solution
KirP4GB_Mainte-F6_FM_forPaper.book Page 57 Thursday, May 12, 2005 11:48 AM
