Paper and Other Media
26
1
D Push the bottom plate down until
it locks into place.
E Load envelopes into the envelope
feeder unit, with the print side
down and the flap on the left as
shown in the illustration.
Important
❒ Confirm that the envelope flaps
are securely folded down, and
that there is no air inside the en-
velopes.
Note
❒ Confirm that the top of the stack
is not higher than the limit mark
on the side guides.
❒ Confirm that the envelopes fit
under the side guides.
❒ Do not push the stack of enve-
lopes with too much force.
F Pinch the side guides, and then
slide them along the edge of the
envelope stack.
G Pinch the rear guide, and then
slide it along the edge of the enve-
lope stack.
H Lift the front of the tray, and then
slide it carefully into the printer
until it stops.
Important
❒ Do not slide the paper tray in
with force. If you do, the front
and side guides might move.
ZKGP360E
ZKGP380E
ZKGY370E
ZKGY390E
ZKGP340E
KirP4GB_Mainte-F6_FM_forPaper.book Page 26 Thursday, May 12, 2005 11:48 AM
