Paper and Other Media
14
1
D Lift the front of the tray, and then
slide it carefully into the printer
until it stops.
Important
❒ Do not slide the paper tray in
with force. If you do, the front
and side guides might move.
Reference
For more information about
type, size and feed direction of
paper that can be loaded in the
tray, see p.3 “Paper and Other
Media Supported by This Print-
er”.
When you change the paper
size see p.14 “Changing the pa-
per size”.
Changing the paper size
Important
❒ Confirm that the setting of the pa-
per size dial matches the paper size
and feed direction of the paper in
the tray, otherwise the printer
might be damaged, or printing
problems might occur.
The following explanation uses the
example of “Tray 1” for the paper
tray.
A Lift the paper tray slightly, and
then pull it out until it stops. Ad-
just the paper size dial to match
the size and feed direction of pa-
per in the paper tray.
Important
❒ If you want to use the paper size
and feed direction that are not
indicated on the paper size dial,
set the dial to “p”. In this case,
you should set the paper size
using the control panel.
B Lift the front side of the tray, and
then pull it out of the printer.
C If you load paper larger than
A4K or 8
1
/
2
× 11K, you should ex-
tend the tray as follows:
Note
❒ You cannot load paper smaller
than A4K or 8
1
/
2
× 11K, if the
tray is extended. In this case, re-
turn the tray to its standard
length.
ZKGY150E
AGN025S
ZKGY140E
KirP4GB_Mainte-F6_FM_forPaper.book Page 14 Thursday, May 12, 2005 11:48 AM
