Radio PC Card Configuration 35
E-EQ-MX2RG-L-ARC MX2 Reference Guide
Cisco Parameters
The following is a list of parameters that can be modified in the NET.CFG file. To set the TCP/IP
parameters see the SOCKET.CFG file documentation.
Link Support
Parameter used to define resources for the LSL.COM file. Any modifications may cause resource
conflicts.
Protocol
Instructs TCP/IP stack to bind to radio driver.
SSID
Identifies the 802.11B wireless network the station will connect to.
Default: “”
Note: Setting this value to “” will enable the station to connect to any IEEE 802.11b network.
FragThreshold
Packet size to start fragmenting.
Default: FragThreshold 2312
RTSThreshold
Packet size to start sending RTS/CTS.
Default: RTSThreshold 2312
DataRateX
To set a data rate other than 11 MB default uncomment rate desired and all data rates less than
that rate. Example to set for 5.5MB data rate uncomment the DataRate1, DataRate2 and
DataRate3.
1 Mbps supported data bit rate
DataRate1 0x02
2 Mbps supported data bit rate
DataRate2 0x04
5.5 Mbps supported data bit rate
DataRate3 0x0B
11 Mbps supported data bit rate
DataRate4 0x16
RefreshInterval
Inactivity time to check association with AP
RefreshInterval 10000
