ROM-DOS Commands 97
E-EQ-MX2RG-L-ARC MX2 Reference Guide
Syntax
REMSERV.EXE d: [/Tnnnn] [/H] [/Bnnnn][+|-] [/COMn] [/IRQn]
[/Tnnn] [/S]
where d: represents the letter of the drive the server makes available to the client.
The default is /B115+ /COM1 /T2
Option Description
/Bnnnn Selects the baud rate for transmission. Available baud rates are 300, 1200,
2400, 4800, 9600, 19200, 38400, 57600, and 115000. The default baud
rate is 115000.
+/- The plus sign (+) after the BAUD specifies packet-style transmission and
is recommended for any baud rate over 19200. The default setting is to
include + for packet transmission. Use the minus sign (-) to specify
polling operation under Microsoft Windows 95. By default, packet
transfers will be used for all baud rates higher than 9600. Both sides must
agree on using either (+) or (-).
COMn Selects the communication port. Available ports are 1, 2, 3 or 4. COM1 is
the default port.
/IRQn Set the IRQ for the communications port. Valid settings are 3 – 15.
Default is IRQ3 for COM 2 and COM4, and IRQ4 for COM1 and COM3.
/Tnnn Sets the time-out in the range of 2 to 3,640 seconds. 15 seconds is not
unusual for Flash drives.
/S Instructs REMSERV to run without any display output (Silent).
/H
Selects hardware handshaking for flow control.
Example
To select drive B: as the available server drive at 115000 baud, packet transmission, using COM1, enter
REMSERV B:
To set drive C: as the server disk at 38400 baud, without packet-style transmission, on COM2,
with a timeout of 10 seconds, enter:
REMSERV C: /B38400 /COM2 /T10
