Commands
285
CONFIG DELETE
Cfg
Deletes Configuration number
Cfg.
Cfg
must be in the range of 1-8.
UPLOAD
Port;Cfg
This command uploads the
configurationstoredinlocation
Cfg
to the port specified by
Port
.
Port
must either be 1284 or SERIAL.
Cfg
may be 1-8 or ALL.
DOWNLOAD
Cfg
This command saves the
configuration data that follows as
configuration
Cfg. Cfg
must be 1-8
or END.
RESET Reboots the printer.
LP MODE n/a
Protocol Protocol
must be 0-4. This
command resets the software
protocol, and is selected as follows:
0 - P-Series
1 - P-Series XQ
2-SerialMatrix
3 - Proprinter III XL
4-EpsonFX-1050
FILE_IO
(DISK_IO)
CAPTURE
Filename
Captures all incoming data into a file
named
Filename
. Receipt of a
FILE_IO–CAPTURE command
without the
Filename
parameter will
forcethefiledatatobewrittento
flash, and will end the file capture.
DRIVE
Letter
This command is parsed for
backwards compatibility. However,
since the flash file system is a single
device, the drive letter will be
ignored.
DEL
Filename
The DEL command will mark a file
as deleted. The space the file
occupied will be freed the next time
the printer is powered up.
Table 80. PTR_SETUP Commands (continued)
Command Sub-Command Parameter Description
