5. WEB SOFTWARE
5-8
In the above connection list, Standard IP Packet Data Connection Service is
connected first.
• In the [Status] field, "Not connected" changes to "Connected" (displays in
green).
• The display in the [Operation] field changes from "Connect" to "Disconnect".
6. Open the desired application software and begin data communication.
Applications are not limited to only those marked with the P mark (applications
preset at section 6.1.5.) You can use any software that appears after the 2nd ap-
plication in the list. For example, when the connection list was as shown above,
Windows Media
®
Player uses the 32 kbps streaming IP packet communication
service and all other applications use the standard IP packet communication ser-
vice.
How to disconnect from the internet
Do the following to disconnect from the internet:
1. Click [Main] in the menu bar.
2. Click [Data connection]. The [Data connection] screen is displayed.
3. Click [Disconnect] for the services to disconnect. When disconnecting, the mes-
sage "Now disconnecting..." is displayed. When disconnected, the message
"***disconnection success." is displayed. (***: Service and application)
Note 1: If you disconnect a service marked with a P mark, all other connected ser-
vices will disconnect.
Note 2: If the disconnection fails, "***disconnection failure." is displayed.
4. Click the [OK] button to close the message. The [Status] field displays "Not Con-
nected", the [Operation] button shows "Connect".
