Filter
Top Products
4 - 10
The two piece tub is held together with a number
of metal clamps which can be removed by prying
them off with a flat bladed screwdriver.
(Fig. 4-
38)
Fig. 4-38
The tub can now be separated and the basket
can be pulled from the back half of the tub.
(Fig.
4-39)
REASSEMBLING AND
REINSTALLING THE
TUB ASSEMBLY
When reassembling and reinstalling the tub as-
sembly, take note of these special procedures.
1. When reassembling the tub, be sure
to install all the metal clips all around
the tub. A hammer may be necessary
to do this.
2. When reinstalling the heater element,
be sure it is inserted properly in the
retainer inside the tub.
(Fig. 4-40)
Fig. 4-39
3. When reinstalling the tub, be sure to
hook the springs into the holes to-
wards the front of the tub as well as
the front of the cabinet.
4. A small piece of duct tape may be
necessary to hold the flat nut in place
when replacing the front bottom con-
crete weight.
(Fig. 4-41)
Fig. 4-40
Heater
Retainer
Fig. 4-41
The gasket seam is located at the top of the tub
to minimize the possibility of a water leak.
Gasket Seam