Filter
Top Products
2 - 6
INSTALLATION INSTRUCTIONS
Pedestal
! WARNING
EXCESSIVE WEIGHT HAZARD
Use two or more people to move washer
and dryer.
Failure to do so can result in back or other
injury.
Before you start...
Important: If the washer is already installed,
it must be uninstalled.
See installation instructions that came with the
washer for tools required.
Uninstalling the Washer
1. Turn off the hot and cold water faucets.
2. Briefly start the wash cycle to release
any pressure in the fill hoses.
3. Unplug the power supply cord.
4. Remove the “HOT” and “COLD” fill
hoses from the back of the washer.
5. Disconnect the drain hose from the
washer and drain any water in the hose
into a bucket.
6. Pull the washer away from the wall so it
can be tipped on its back.
7. Protect the floor with a large piece of
cardboard cut from the pedestal carton.
Lay the washer on its back so that the
cardboard is under the entire lower back
edge of the washer.
(Fig. 2-2)
Go to
“Installing the Pedestal”.
Fig. 2-2
Fig. 2-1