Filter
Top Products
3 - 1
THEORY OF OPERATION
INTRODUCTION
The
and
Front-Loading Automatic Washers present a number of new features and
operating characteristics quite different from previous models. In addition to the introduction of
front-loading operation, The washers
contain a number of unique operating features designed to
increase clothes cleaning ability while offering very high water and energy conservation.
Water System
The water system consists of the hot and cold water inlet valves, a water temperature sensor, a water
flowmeter and control and the dispenser distribution system along with a traditional pressure switch.
Water Inlet Valves -
The hot and cold water inlet valves are located at the back of the washer. These valves receive a control
signal from the Central Control Unit to manage the temperature of incoming water. The temperatures
are determined by the specific wash cycle selected and a temperature sensor located in the wash tub.
To improve cleaning of heavily soiled clothing and to provide a sanitizing feature, the water tempera-
ture can be increased through the use of a heating element located in the bottom of the tub, (GHW9200
model only).
Cam Follower
Cam
Dispenser
Motor
Flowmeter
Fig. 3-1
Flowmeter
Water flow, or the quantity of water introduced throughout
any cycle is monitored by a flowmeter and Central Control
Unit. When the flowmeter registers a maximum of 10.5 gal.
(40 L), and the Central Control Unit has not detected the
pressure switch trip, the water valves will be shut off and an
error code will show in the digital display. The flowmeter is
also used to introduce additional water into the tub for higher
water levels, based on cycle requirements. Refer to page 6-
12 for more details.
Dispenser Distribution System
All wash and rinse water is introduced into the wash tub through a Dispenser Distribution System lo-
cated in the top left corner of the washer. The system consists of a motor that turns a cam gear. The cam
follower will divert the incoming water to one or more of the follow water inlet modes:
• Detergent Dispensing
• Bleach Dispensing
• Fabric Softener Dispensing
• Rinse Dispensing (no additives)
Fig. 3-2