Filter
Top Products
2 - 4
There are 4 bolts in the rear panel of the washer that
support the suspension system during transportation.
1. Using a ½ in. (13 mm) wrench, loosen each of the
bolts.
2. Once the bolt is loose, move it to the center of the
hole and completely pull out the bolt, including the
plastic spacer covering the bolt and the cable
attached to the bolt. The power cord will be at-
tached to all 4 bolts.
3. Once all 4 bolts are removed, remove the power
cord from each bolt holder, and discard bolts,
plastic spacers, and cables.
4. Close the holes with the transport bolt hole plugs.
Route the Drain Hose
Proper routing of the drain hose protects your floors
from damage due to water leakage. Carefully read and
follow these instructions.
The drain hose is connected to your washer.
To prevent drain water from going back into the
washer:
• Do not straighten the drain hose, and do not force
excess drain hose into standpipe. Hose should be
secure, but loose enough to provide a gap for air.
• Do not lay excess hose on the bottom of the laun
dry tub.
Floor drain
You may need additional parts. (See Floor Drain under
“Alternate Parts You May Need.”)
Connect the Inlet Hoses
Connect the inlet hoses to the water faucets
Make sure the washer basket is empty.
1. Attach the hose with the red color indicator to the
hot water faucet. Screw on coupling by hand until
it is seated on the washer.
2. Attach the hose with the blue color indicator to the
cold water faucet. Screw on coupling by hand un-
til it is seated on thewasher.
3. Using pliers, tighten the couplings with an addi-
tional two-thirds turn.
NOTE: Do not overtighten. Damage to the coupling
can result.
4. Turn on the water faucets and check for leaks.
NOTE: Replace inlet hoses after 5 years of use to
reduce the risk of hose failure. Record hose in-
stallation or replacement dates on the hoses for
future reference.
Periodically inspect and replace hoses if bulges,
kinks, cuts, wear, or leaks are found.
Secure the Drain Hose
1. Drape the power cord over the washer top.
2. Secure the drain hose to the laundry tub leg or
standpipe with the beaded strap provided. (See
illustration.)
If the washer faucets and the drain standpipe are
recessed, put the hooked end of the drain hose in
the standpipe. Tightly wrap the beaded strap around
the water inlet hoses and the drain hose.
Do not force excess drain hose into the standpipe.