Filter
Top Products
©2005 Maytag Services 16026502 11
Troubleshooting Procedures
!
WARNING
To avoid risk of electrical shock, personal injury or death, disconnect power to unit before servicing.
CAUTION
!
Due to possibility of personal injury or property damage, always contact an authorized technician for servicing or
repair of this unit.
All safety information must be followed as provided in the Service Manual.
EXIT SERVICE MODE
Rotate Cycle Selection Knob to “Power Off” and press
knob.
or
Allow 5 minutes of inactivity.
or
Disconnect power
DISPLAY/CLEAR SERVICE CODES
Enter Service Mode then set Cycle Selection Knob to
“Rinse & Spin”. Press knob
•
Rinse & Spin LED will blink if codes other than
power interrupt are present.
•
Press knob to view codes. Press once for each
code. Codes are displayed newest to oldest.
Machine beeps three times after last service code is
displayed.
•
To clear codes display a code then
press
and
hold
Cycle Selection Knob until machine beeps twice.
Rinse & Spin LED stops blinking.
•
Refer to chart for Service Codes.
CONSOLE SWITCH TEST
Enter Service Mode then set Cycle
Selection Knob to “
Delicate
” and
press
knob.
•
Power Off LED blinks.
•
Pause and Delicates LED’s are
illuminated.
Rotate the Cycle Selection Knob clockwise
for ascending, and counterclockwise for
decending test mode. Rotate 32 clicks in
the same direction to complete the test.