Filter
Top Products
18
3. First, loosen the four screws on the adaptor using a '+’ type
screwdriver. Next, hold part (D) and turn part (E) following the
arrow until there is a 5 mm gap.
(*): 5 mm
E
D
4. Connect the adaptor to the water tap by tightening all the screws
firmly while lifting the adaptor upwards.
Then tighten the adaptor by turning part (E) following the arrow.
E
5. Connect the water supply hose to the adaptor. If you push part (F)
into the adaptor, the hose automatically connects to the adaptor
with a 'clicking' sound.
After you have connected the water supply hose to the
adaptor, ensure that it is connected correctly by pulling the
water supply hose downwards.
WARNING: Check if the water supply hose is not twisted
or bent. If the hose is twisted or bent, there is a danger of a
water leak and electric shock due to the water leak.
If necessary, you can reposition the water supply hose at
the washing machine end by loosening the L-shaped arm
fitting, rotating the hose, and retightening the L-shaped arm
fitting.
F
6. Turn on the water supply and ensure that there are no water leaks
from the water valve, tap, or adaptor. If there is a water leak, repeat
the previous steps.
WARNING: Do not use your washing machine if there is a
water leak. This may result in electric shock or injury.
If the water tap has a screw type tap, connect the water supply
hose to the tap as shown.
Use the most conventional type of tap for the water supply. If the tap is square or too big, remove the
spacing ring before inserting the tap into the adaptor.
F400E_WF70F5E_NonBubble-03262C-01_EN.indd 18 2013-01-18 �� 1:54:26