Filter
Top Products
Aligning the door
The door must align so that it is flush
with the control panel. If the door is not
flush with the control panel it will not
shut properly.
Example of a flush door:
Example of a door which is not flush
:
To align the door add or remove the
spacers located underneath the door
latch.
Additional spacers are supplied in the
accessory pack.
Please note:
If you use too many spacers the door
will not provide a sufficient seal when
shut.
If this is the case remove one or more
spacers until the door shuts correctly.
After aligning the door test it to make
sure that the seal is adequate.
Installation
59