Filter
Top Products
A fault indicator light comes on but the wash programme
continues as normal.
What to do if ... Possible cause Remedy
The Check drain
light flashes.
The drain outlet is re
-
stricted.
Clean the fluff (drain) filter and
drain pump.
The Check inlet
light flashes.
The water inlet is re
-
stricted or the water pres
-
sure is too low.
–
make sure the stopcock is
opened wide enough.
–
make sure the inlet hose is
not kinked.
The filter in the inlet hose
is dirty.
Clean the filter.
The Excess deter-
gent check light
comes on.
Excessive foam has built
up during washing.
Use less detergent next time
and follow the recommendation
on the packaging.
The "Locked"
check light is on.
Programme locking is
switched on.
Switch off the programme lock-
ing.
The "Final spin"
indicator light
flashes in the
programme se-
quence display.
The final spin has not
taken place. The machine
detected an imbalance.
– Loosen and re-distribute the
washing.
– Select the programme Spin
or Drain.
–
Take into account the spin
speed of the relevant
programme.
The Anti-crease /
Finish indicator
light flashes in the
programme se
-
quence display.
The position of the programme selector was altered after
the start of the programme. Turn the programme selector
back to the programme previously chosen.
Problem solving guide
45