Filter
Top Products
Adjusting the facia height
The adapter can be adjusted to match
the machine facia to the height of an
adjacent drawer by:
–
altering the position of the nuts
or
–
by removing one or more of the
strips.
Adapter strip adjustment range:
–
max. 10 mm upwards (see arrows il
-
lustrated),
–
max. 25 mm downwards (this re
-
quires additional adapter strip(s) and
longer screws, available from the
Miele Spare Parts dept, or your Miele
dealer).
After adjustments have been made,
cut or pinch off any excess thread.
Fitting the front panel
The front of this appliance can be fitted
with a door panel to match surrounding
units. If the unit is fitted in a MIELE
KITCHEN, a door panel with the appro
-
priate dimensions and the necessary
holes pre-drilled can be provided.
If the kitchen is from a manufacturer
other than Miele, it is recommended
that the panel be cut to size and
holes drilled by a specialist, accord
-
ing to Miele specifications.
The rear side of the front panel must
be completely flat (without profile).
Any unevenness must be levelled
out.
Front panel dimensions:
Height: . . . . . . . . 570 mm (+10/-25mm)
Width: . . . . . . . . . . . . . . . 588 - 596 mm
Thickness: . . max 19 mm (at the edges)
The template provided serves to locate
and drill the fixing holes for non-Miele
kitchens.
Installation
56