Filter
Top Products
53
Refrigeraon Updates
Exit out of service mode and check the accuracy of the ll.
Repeat the process unl the measured ll is accurate.
For under lling: The value in step 49 needs to be set lower.
Press SW2 to decrease the number which increases the volume.
For overlling: The value needs to be set higher.
Press SW3 to increase the number which decreases the volume.
To exit Diagnoscs and lock in the new seng:
Press SW1 and SW2 simultaneously for 3 seconds.
Note: Always check calibraon aer replacing any component associated with the
water dispenser system.
KitchenAid & Whirlpool Measured Fill Calibraon Procedure (cont.)
Whirlpool SXS Refrigerators Produce Too Much Ice
GSF26C4EX*00, GSF26C5EX*00,
GSS26C4XX*00, GSS26C5XX*00, WSF26C3EX*00
Code Date: HRY01 – HR040
Concern: Refrigerator connues to produce ice even though the ice bin is full.
Cause: If the touch-pad is in the “Lock-Out” mode and the unit loses power (the “Lock-Out
feature is cancelled out during a power lose), once power is restored, the ice maker will
constantly make ice and not shut o unless the unit is programmed back into the “Lock-Out”
mode and then again programmed to the Unlock posion.
Soluon: A soware revision has been implemented into the control. Order a new control
board (Part # W10419171).