26
Fabric Care Product Updates
Maytag and Whirlpool Dryers
Motor Pulley Comes Loose (connued)
c.) Apply a coang of medium
strength thread lock (Thread lock
242 -part # 4210460) to the enre
length of threads on the blower
sha. See gure 3.
Install pulley and ghten.
d.) Use a crescent wrench or 1 1/8”
open end wrench on the pulley nut
and a ½ square drive ratchet to hold
the blower wheel and ghten. See
gure 4.
Note: If a torque wrench is available,
the torque specicaon is 120 in.
lbs. or 10 . lbs.
Install belt and check.
Note: The belt should not touch the
tab on the blower housing, see gure 5.
e.) Install all panels and screws.
f.) Plug in dryer or connect power.
g.) Operate the dryer and check op-
eraon.
Figure 3
Figure 4
Figure 5
Apply thread lock
1 1/8” Nut
1/2” Square Opening in Fan