Filter
Top Products
48
6.5 Device Settings
6.5.1 Network
The Network Settings panel as shown in Figure 6-19 allows changing network related
parameters. Each parameter will be explained below. Once applied the new network settings
will immediately come into effect.
Figure 6-19. Network Settings
Warning
The initial IP configuration is usually done directly at the host system using the
special procedure described in Table 4-1.
Warning
Changing the network settings of the KVM-9000 might result in losing connection to
it. In case you change the settings remotely make sure that all the values are correct
and you still have an option to access the KVM-9000.
IP auto configuration
With this option you can control if the KVM-9000 should fetch its network settings from a
DHCP or BOOTP server. For DHCP, select “dhcp” , and for BOOTP select “bootp”
accordingly. If you choose “none” then IP auto configuration is disabled.
IP address
IP address in the usual dot notation.
Subnet Mask
The net mask of the local network.
Gateway IP address
In case the KVM-9000 should be accessible from networks other than the local one, this
IP address must be set to the local network router's IP address.