Filter
Top Products
10
Step 8 (Option)
Connect the type A connector of USB A-B cable to the host system, while using remote mass storage
control.
Step 8
Connect Ethernet and/or modem, depending how you want to access KVM-9000
3.2.1 Ethernet connection
The rear side of KVM-9000 provides a RJ-45 connector for Ethernet. The connector is used either for
a 100 Mbps 100BASE-TX connection or for a 10 Mbps 10BASE-T connection. The adapter can sense
the connection speed and will adjust to the appropriate operation mode automatically.
3.2.1.1 10 Mbps Connection
For 10BASE-T Ethernet networks, the Ethernet adapter uses Category 3, 4, or 5 UTP cable.
To establish a 10 Mbps connection, the cable must be connected to a 10BASE-T hub.
Make sure that the cable is wired appropriately for a standard 10BASE-T adapter.
Align the RJ-45 plug with the notch on the adapter’s connector and insert it into the
adapter’s connector.
3.2.1.2. 100 Mbps Connection
For 100BASE-TX Fast Ethernet networks, KVM-9000 supports Category 5 UTP cabling. To
establish a 100 Mbps connection, the cable must be connected to a 100BASE-TX hub.
Make sure that the cable is wired appropriately for a standard 100BASE-TX adapter.
Align the RJ-45 plug with the notch on the adapter’s connector and insert it into the
adapter’s connector.
INTERNET
Modem