Filter
Top Products
27
Maintenance
General Maintenance
Cabinet and Motor: Keep the inside of the
cabinet clear of sawdust and wood chips. Vacuum
out the inside of the cabinet and blow out the
inside with an air hose. Make sure the motor fan
and fan cover are also kept clear of sawdust.
Worm Shafts and Trunnions: Use a wire brush
and a cleaner/degreaser to clean worm shaft, and
trunnions. Apply white lithium grease or powdered
graphite to lubricate worm shaft, and trunnions.
Sliding Table: After a days use push the sliding
table all of the way forward and wipe out any
sawdust that may have made it past the wipers.
The important part of the bearing sliders is the
mating grooves (A, Fig. 54) that the bearings ride
along.
Pull the sliding table all of the way forward and
wipe out any sawdust that may have made it past
the wipers. The important part of the bearing
sliders is the mating grooves (A, Fig. 55) that the
bearings ride along.
Add a small amount or lightweight oil to the
bearing grooves, if necessary and run the sliding
table back and forth to work the oil into the
bearings. Wipe off any excess oil.
Table Top: Remove rust from the tabletop with
WD-40 and a Scotch-Brite™ Hand Pad. Keep a
light coat of WD-40 on the tabletop when not in
use.
Blades and Accessories
10” x 40T carbide .....................................709733
10” x 60T carbide .....................................709734
Feather board...........................................709721
JTG-10Q Tenoning Jig.............................708295
Tenoning Jig Adaptor Plate.................708295SS
Tenoning Jig Kit*...............................708295SSK
XACTA Lift................................................708124
Outfeed Rollers ...................................708150PK
Universal Mobile Base .............................708119
Figure 54
Figure 55
*Consists of JTG-10Q Tenoning Jig and Adaptor Plate