Filter
Top Products
20
Blade Guard Assembly
Hardware: Blade Guard Assembly, Splitter Guard
Assembly
Tools: 12mm Wrench, 17mm Wrench or
Adjustable Wrench, 3mm Hex Wrench
1. With a 3mm hex wrench, loosen two set
screws (G, Fig. 34) on the splitter guard
assembly and remove the bracket.
2. Remove the hex nut and lock washer from the
threaded end of blade guard shaft and reverse,
threading the hex nut first, then placing the
lock washer on the shaft.
3. Thread the blade guard shaft (E, Fig. 34) into
rear trunnion through opening at rear of saw.
4. Tighten blade guard shaft. The shaft has a
hole to accommodate a screwdriver.
5. Place upper and lower bracket assembly
(F, Fig. 34) in the upright position and snug
two set screws (G, Fig. 34) just enough to hold
in place.
6. Insert front tab (A, Fig. 35) of blade guard
assembly through insert opening in the table.
Loosen the hex cap screw already installed at
the factory and insert the front tab of the blade
guard. The tab is held in place between the
flat washer and bracket. Leave a 1/8” gap
between the splitter and table. Tighten hex
cap screw
Note: make sure the anti-kickback pawls
(B, Fig. 35) are pointing towards the back of the
saw.
7. Secure rear tab of blade guard assembly to the
upper blade guard bracket with two hex cap
screws (C, Fig. 35). Leave a 1/8” gap between
the splitter and table. Tighten hex cap screws.
Table Insert Adjustment
Hardware: Table Insert
Tools: Straight Edge, 3mm Hex Wrench
1. Adjust table insert (A, Fig. 36) flush with table
by turning four leveling screws (B. Fig. 36).
2. Use a straight edge (C, Fig. 36) to make sure
the insert is flush with the table.
Aligning Blade Guard and Splitter
Tools: 12mm Wrench, 3mm Hex Wrench, Straight
Edge
1. Use a straight edge (E, Fig. 37) to align the
splitter with the saw blade. Be sure the
straight edge rests against the body of the saw
blade and not the saw teeth.
Figure 34
Figure 35
Figure 36
Figure 37
2. Tighten two set screws (G, Fig. 34) on the
bracket assembly.
3. Make sure the splitter is level with the table and
approximately 1/8" above the table. The space
between the splitter and the table keeps the
splitter from binding on the table when the
blade is tilted to 45°.