Filter
Top Products
76
WFL 2060 Service Tips
WFL 2060 Service Tips
--
--
WFL 2060 Not Running
WFL 2060 Not Running
WFL2060 drain pump is
located at washer right
front corner (photo
viewing rear of washer)
Push on white (or gray) drain
pump electrical connector (if
it has been pulled off).
NOTE: Occasionally, WFL2060 washers have been set up for sales
demonstration and not reconfigured for normal use when they were sold.
HINT: When repairing WFL2060 washers that won’t run at all, check the
drain motor first to see if its connected.
NOTE: WFL2060 washers cannot be set up for sales demonstration
mode since the control senses the drain motor during start up.
HINT: If WFL2060 washers have been set up for sales demonstration
and not reconfigured for normal use, all lights will turn on and washers
won’t run. If this occurs, check the drain motor first
.
HINT: If electrical tape has been used on the washer, carefully clean off
all tape adhesive residue to insure good electrical connections.
Shipping bolt
locations
IMPORTANT
HINT: When repairing WFL2060 washers that won’t run at all, if the drain
motor has been disconnected for sales display, please check the
following:
• Make sure the drain motor is reconnected.
• Make sure the fuscia label has been removed from the rear of the the
washer.
• Make sure the shipping bolts have been removed.
1st Edition/Revision 5 (1/20/04)