Filter
Top Products
WFL 2060 & WFR 2460 Service Tips
WFL 2060 & WFR 2460 Service Tips
-
-
-
-
Troubleshooting (1)
Troubleshooting (1)
73
Symptom Problem Solution
Washer won’t start.
Electricity is disconnected
or has been turned off.
Cycle selector knob or
control module has failed.
Make sure washer is connected to an appropriate 240V, 60 Hz
circuit (according to local codes). Turn on electricity.
Control module has onboard cycle selector knob. Check
voltage output to water inlet valves and drum motor (when
they’re energized). If no voltage, replace faulty control module.
Washer won’t fill.
Water supply turned off.
Water inlet hose filters
(strainers) blocked.
Water pressure too low.
Control module has
failed.
Water inlet valve(s) has
failed.
Turn on water supply.
Check water inlet hose filters. Clean if dirty. Replace filters if
damaged.
Check incoming water pressure.
Check voltage output to water inlet valves (when they’re
energized). If no voltage, replace faulty control module.
Measure resistance of water inlet valves (~ 2.7 – 4.5 kΩ).
Replace inlet valve(s), if faulty.
Washer won’t drain.
Drain pump or motor
protector has failed.
Control module has
failed.
Disconnect drain pump and measure resistance at connector
(~ 80 – 94 Ω). Replace drain pump if faulty.
Check voltage output to drain pump when it’s energized). If no
voltage, replace faulty control module.
WARNING! Unplug washer before starting any repairs.
1st Edition/Revision 5 (1/20/04)