Filter
Top Products
WFL 2060 Service Tips
WFL 2060 Service Tips
--
--
Test Program (4)
Test Program (4)
55
Fault Possible Causes
Flashing
Lights
Program Fault
Occurred
Door open or
won’t lock
Door left open.
Faulty door latch or door lock.
Wash
No water
filling
Water shut off.
Inlet strainer filters blocked.
Water pressure too low (< 1 bar)
Wash
No heating
Faulty heater.
Voltage too low.
Excessive scale on heating element.
Test
No draining
Blocked sensor.
Faulty water level controller.
Faulty or blocked drain pump.
Wash
Motor won’t
run
Faulty speed control.
Triac short-circuited.
Faulty reversing relay.
Test
Overheating
Faulty control module.
Test
NTC failed
(short or open
circuited)
Faulty wire harness.
Faulty NTC.
Test
Door locked
Rinse/S
p
in
Wash
Door locked
Rinse/S
p
in
Wash
Door locked
Rinse/S
p
in
Wash
Door locked
Rinse/S
p
in
Wash
Door locked
Rinse/S
p
in
Wash
Door locked
Rinse/S
p
in
Wash
Door locked
Rinse/S
p
in
Wash
HINT: Using the test program can cut down repair times & eliminate repeat calls from misdiagnosing problems.
1st Edition/Revision 5 (1/20/04)