Filter
Top Products
WFL 2060 Service Tips
WFL 2060 Service Tips
--
--
Test Program (5)
Test Program (5)
56
Comprehensive Test Sequence Chart
HINT: “n” = spin
speed & n
max
=
max. spin speed
of 1000 RPM.
HINT: Rinse/Spin light goes out when max. speed of
1000 RPM is reached. Both Door locked and
Rinse/Spin lights come on when test has ended.
HINT: Before leaving, make sure door isn’t locked. To drain washer to
open locked door (locked during wash or test):
• Exit test program by turning washer off. Turn washer on, then rotate
cycle selector knob to Drain and push Start button.
• Door can be opened after washer drains and Door locked light
flashes (Door locked light flashes ~ 2 minutes after washer drains).
HINT: Water valves are tested in order:
• Left side of cold water valve (Pre-wash)
– flows into right
side of dispenser.
• Hot water valve
– flows into left side of dispenser.
• Left & right sides of cold water valve (Wash) – flows into
right side & center of dispenser.
To exit test program (from any test), turn unit off by pressing
"ON/OFF" button.
1st Edition/Revision 5 (1/20/04)