Filter
Top Products
WFL 2060 Service Tips
WFL 2060 Service Tips
--
--
Test Program (1)
Test Program (1)
52
The WFL 2060UC washers have test programs enabling the washers to
self-diagnose problems, including listing the last fault code.
To enter component test program for WFL 2060 washers (to test individual parts or check last
wash fault):
♦ Rotate cycle selector knob to Off position.
♦ Push and hold
Start button (or Rinse Plus and Quick Wash buttons at the same time), then rotate cycle selector knob
ccw to Permanent Press Cold position. After rotating cycle selector knob, keep holding Start button (or Rinse Plus and
Quick Wash buttons) at least 3 seconds until Door locked & Rinse/Spin lights come on. Washer is now in the
component test program.
♦ Lights will flash
for wash faults below. Fault shown will be the last fault code on the washer (see fault chart below).
♦ When test program has been entered
:
♦ Door locked & Rinse/Spin lights will come on (and stay on).
♦ Select individual parts to test by rotating cycle selector knob as shown on next page. Don’t rotate cycle selector
knob through Off position while selecting tests (so washer won’t shut off).
♦ Once part to test has been selected, start test by pushing Start button. Push Start button again to end any test
(except for rotating cycle selector or spin speed knob to end motor test).
♦ To exit test program, push Start button.
Door locked
Rinse/Spin
Wash
NOTE: Fault displayed will be 1
st
fault
that occurred since last time washer
was turned on.
NOTE: Door locks for all water fill and
drain tests. Door unlocks ~ 30
seconds after drain pump
test ends
(after all water has been drained).
1st Edition/Revision 5 (1/20/04)